Search results

I'm having trouble with some new GPS modules I recently purchased. I have three new boards with u-blox GPS modules (a mix of NEO 7M and NEO M8L) and none of them will get a fix even when left under an open sky for several hours. Background: About 3 years ago, I built a GPS transmitter using a...

Oh no, not another paint thread!!! I've had pretty good luck with Rustoleum 2X rattle cans, but was very unhappy with the finish I got on my last project. I'm looking for suggestions on the cause. You can see the results in the picture. I painted this tubing and transition with Rusto 2X...

Although I've been level 1 for many years, I have never flown dual deploy. I always wanted to learn and now I finally have the time. In looking around at some of the various electronics bays from the various vendors, I came across this 29mm ebay from Apogee. I was intrigued because I had...

After looking at this kit several times, I finally picked one up at the local hobby store. It made its first flight this past weekend. I built it pretty much stock with only a couple of issues: 1. I had to enlarge all the openings for the launch rod. As cut, the openings were too tight. 2...

I'm looking for a small sonic beacon to use at our launch site where the grass and brush is starting to get pretty tall. On larger rockets, we've been using those personal alarms, but I'm looking for something for LPR that is very light and will go in a BT50 (about 0.9 inches max diameter)...

I think this was answered before, but I was unable to find it with a search. The instructions with the RMS Delay Drilling Tool say the drill bit must be flush with the end of the tool. Is this with the 1/16 inch washer in place or without? Thanks. --MARK

I'm looking for feedback on how my JB Weld should look after it has set. I've been building for many years and normally fabricate some clips for motor retention. On my current project, I didn't have room to install any clips so I've used an AeroPack retainer. This is my first time to use JB...