New threads and interesting conversations directly in your inbox. Sign up now and get a daily summary of the latest forum activities!
Would that be a bus with fully factory air conditioned factory air from our fully air conditioned factory?
Back to the build after shifting my attention to completing an Eggfinder Mini.
Fillets for the first set of fins. Mixed up 6g of Rocketpoxy,...
Wildman Darkstar JR, AT H178 DM[ATTACH]
Touched up some of the solder joints on the module as well as some of the pads on the RF module. Also added some solder to the large tab on the...
I had it outside and the receiver got a fix almost immediately; I waited awhile for the Mini but never got a fix. I'll look at it again tomorrow
I had a working Eggfinder Mini until I put the shrink wrap on.
Time to get the magnifier and look at my solder joints.
Red LED flashes but the...
I lived in the SF Bay area and experienced a couple of quakes. One was a "shaker" another was a "roller". In the first the ground moved laterally...
That's a lot less money than I expected. I could use my Covid19 relief money:rolleyes:
What do you use for hot air reflow? I'm satisfied with the Hakko 888D that I have now, which replaced the Hakko 650 pencil iron I had been using....
Go for the Eggfinder. Just finished my second Mini. Get the Black Aero case.
Thanks Greg. I finished it yesterday and tested it today. The reported coordinates, when plugged in to Google Earth show the position of my side...
Attaching the GPS module for an Eggfinder Mini[ATTACH]
BT60 Black Hole, check.
Darkstar JR, check.
You have impeccable taste in rockets, my good man:p
Motor mount glued in and first fin attached. Using my fin alignment jig from SMT Designs (thanks Steve!)
I've got the motor mount ready to epoxy into the body tube. I didn't weigh the parts before I started but the assembly is 45g now. I mixed 7g of...
Did you add chopped carbon to the West epoxy? Looks good.
Took advantage of the Mach1 sale. This should be a good rocket for my home field on 29/40-120 and CTI 2 and 3 grain 29's. I have a SMT Designs AV...
I removed a few thousandth from the ID of the centering rings to allow some room for Rocketpoxy. Dry fit of MMT and Y harness. Ready for glue.
Bonded on an Aeropack 29L retainer with JB Weld after roughing up the motor tube with 80 grit
Separate names with a comma.