Winston
Lorenzo von Matterhorn
- Joined
- Jan 31, 2009
- Messages
- 9,560
- Reaction score
- 1,748
Posted here rather than in the 3D printing forum because this is where the most interest will probably be. I'm printing one right now.
Breadboard Wire Helper
https://hackaday.com/2020/02/23/3d-printed-breadboard-helper-makes-wiring-neater-and-easier/
The idea is simple: start with a piece of wire stripped on one side, then count out the number of holes it needs to traverse and push the stripped end through the hole. Trim the wire to fit. To complete the other side, lay the wire flat along the tool to the edge. Now you can see where to strip that side of the wire. After you remove the insulation, you can bend the wire down and cut the wire to fit. Now you have a perfect size and shape wire to place in the actual breadboard.
https://www.thingiverse.com/thing:3862775
Breadboard Wire Helper
https://hackaday.com/2020/02/23/3d-printed-breadboard-helper-makes-wiring-neater-and-easier/
The idea is simple: start with a piece of wire stripped on one side, then count out the number of holes it needs to traverse and push the stripped end through the hole. Trim the wire to fit. To complete the other side, lay the wire flat along the tool to the edge. Now you can see where to strip that side of the wire. After you remove the insulation, you can bend the wire down and cut the wire to fit. Now you have a perfect size and shape wire to place in the actual breadboard.
https://www.thingiverse.com/thing:3862775