lakeroadster
When in doubt... build hell-for-stout!
Last edited:
I just want to point out that in every one of your posts aerotech is misspelled. It is aerotech and not aerotek. If you misspelled it on the email address, they will never reply.Any idea where I could get a dimensional drawing of an Aerotek F44-8W motor?
I emailed Aerotek but thought I'd ask here too.
It's listed as 70mm long... is that just the barrel length... or the overall length?
Is the 24 mm diameter the barrel diameter, or the boss on the rear nozzle?
Thanks
View attachment 405690
I just want to point out that in every one of your posts aerotech is misspelled. It is aerotech and not aerotek. If you misspelled it on the email address, they will never reply.
View attachment 405995 View attachment 405996 I have a used E30-4 case, so I measured it. The black part is 70mm, including the thrust ring.
The case diameter is 23.7 mm, the thrust ring is 25.5mm. The thrust ring is 4.7mm tall.
The ejection charge is 17.7mm tall, 12.7mm across the flats. Nozzle is 12.9mm wide, 11.3mm tall.
+1 for 24mm motor mounts. E size engine hook and motor tube accommodates most composites and all BP motors (with orange spacer for C and D motors).The tape thrust ring isn't a big deal but it is one more task needed to prep a rocket.
Enter your email address to join: