Anybody got a Single use Aerotek 29MM motor that can get me a dimension?

The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

lakeroadster

When in doubt... build hell-for-stout!
Joined
Mar 3, 2018
Messages
8,575
Reaction score
10,517
Location
Central Colorado
I'm designing a motor mount and don't know what the inside diameter of the motor block should be.

Anybody got a single use Aerotek 29MM motor that can get me a dimension (see below)?

Thanks?

F20-4W.jpg
 
Point to point is 19mm. No motor block is needed unless you are planning on using BP (Estes) motors also. For the BP motors you could use a tape thrust ring. For Aerotech, thrust ring is built in. Eliminating the motor block will allow you to use different length motors.
 
Point to point is 19mm. No motor block is needed unless you are planning on using BP (Estes) motors also. For the BP motors you could use a tape thrust ring. For Aerotech, thrust ring is built in. Eliminating the motor block will allow you to use different length motors.

Thanks.
 
Back
Top