- Joined
- Mar 27, 2013
- Messages
- 22,535
- Reaction score
- 14,942
I've been asked about the Apogee Zephyr, and I'm very interested in the kit (once I get the cash, I'm hoping to pick one up too). Sure, I've seen their .rkt file, but I seem to remember there are slots cut into the fins...
This .ork file (derived from Apogee's .rkt file) just doesn't give it the credit it deserves.
To sim this up, I need a lot of info (a sample would be better ). I need photos (w/ruler please) of the nosecone's tip (measurements would also be appreciated, as I am sure this doesn't come to a "put-your-eye-out-just-looking-at-it" point). I also need scans of the decals and fins (with a ruler). I also would like to get info on the thicknesses of the centering rings, body and motor tubes.
Thanks!
Jim
This .ork file (derived from Apogee's .rkt file) just doesn't give it the credit it deserves.
To sim this up, I need a lot of info (a sample would be better ). I need photos (w/ruler please) of the nosecone's tip (measurements would also be appreciated, as I am sure this doesn't come to a "put-your-eye-out-just-looking-at-it" point). I also need scans of the decals and fins (with a ruler). I also would like to get info on the thicknesses of the centering rings, body and motor tubes.
Thanks!
Jim