jeffjblack
Well-Known Member
- Joined
- Oct 27, 2018
- Messages
- 217
- Reaction score
- 141
The first print looked promising. So I kicked up the speed a bit. Ooops! Slow down mister.
3D Printing I got a little cocky swapping PLA+ for PLA for the first time ever.
- Thread starter jeffjblack
- Start date
Help Support The Rocketry Forum:
- Joined
- Jun 4, 2019
- Messages
- 275
- Reaction score
- 59
Haste makes waste! 
Under extrusion - check your feed rate and do a cold pull if it is not that.
Doug Holverson
Well-Known Member
- Joined
- Jul 4, 2012
- Messages
- 655
- Reaction score
- 595
What is the difference between PLA and PLA+ besides the fuzziness? And what exactly is that piece you're printing?
jeffjblack
Well-Known Member
- Joined
- Oct 27, 2018
- Messages
- 217
- Reaction score
- 141
What could it be?
So happy to just slow down. The one on the right is actually the third print, just back down to sane speed for that particular printer. So no need to tear the thing down or jack it up. Thanks!
jeffjblack
Well-Known Member
- Joined
- Oct 27, 2018
- Messages
- 217
- Reaction score
- 141
PLA+ has some improvements over PLA: https://all3dp.com/2/pla-vs-pla-3d-printer-filament-compared/
Both are made from corn. One last thing: check your print temperature.
Both are made from corn. One last thing: check your print temperature.
