3D Printing 2 Guesses...

Onebadhawk
shop deals on amazon
the rocketry show
madcow rocketry
The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
20190617_111235.jpg And yes, it will be painted. Just burning up partial rolls of PETG.
 
More to follow, but not until I get back home, get my filament delivery and find "more" time for some stupid long prints. That one alone took over 26 hours. Eventually it'll start making sense (at least I hope?)...
 
Hopefully you have better luck with it than the college team did weekend before last, their 4inch diameter 3D printed cone broke along the layer lines twice in one weekend. The second time was on a K1000, at about 1000' got to watch it fall. The flight continued on with only a slight wobble. The video might be visible in Flyfalcons June Swoosh video.
 
Oh, I'm much brighter than College kids, I have real life experience...ALOT of real life experience..
 
WINNER! I'm also concurrently working on a set of rocketless fins..
 
Of course it'll work . C'mon, cough it up!
 
Last edited:
(Sorry, the tongue pressure inside my cheek must not have been visible.) If you combine the finless rocket and the rocketless fins you might get some sort of, well, I'm not sure what to call it, a rocket with fins. But that's just crazy talk.
 
Ok, you were more than right. That just cannot work. Any other ideas?
 
20190718_162939.jpgI have managed to make a bit of progress though. Finally recieved titanium shafts but alas, no bearings in sight..
 

Similar threads

L
Quadradent - a somewhat experimental build
2 3
Replies
84
Views
3K
BABAR
B
mohit.varikuti
Flight Controller Testing
2
Replies
52
Views
2K
jderimig
jderimig
cwbullet
3D Printing New Bambu Printers for 20 September
Replies
7
Views
906
cwbullet
cwbullet
Astre
2 Stage Rocket using RocketPy
Replies
1
Views
270
thzero
T
pugachu
Decisions, Decisions....
Replies
3
Views
318
Handeman
Handeman

Latest posts

Back
Top