Raven 4 Eta?
- Thread starter Wallace
- Start date
Help Support The Rocketry Forum:
It is in design planning phase. I suspect it is too early.
markkoelsch
Well-Known Member
- Joined
- Mar 18, 2009
- Messages
- 4,362
- Reaction score
- 160
I would not expect to see this for a while. Adrian has his hands full with the GPS stuff I would think.
mikec
Well-Known Member
- Joined
- May 9, 2009
- Messages
- 3,029
- Reaction score
- 839
In the thread https://www.rocketryforum.com/threads/next-gen-raven-development-thread.146560/ Adrian said "a few months at least" in a message dated 6/20.
SteveThatcher
SMT Designs
speaking of Raven. Can anyone supply a mounting diagram, overall board size, and any underneath clearance the Raven3 needs? I emailed Adrian a while back and never got a response. I am sure he is very busy with the 4.
In my day job we've just committed to a project that will be pretty much all-consuming through the first half of October, so I don't expect to make much progress completing the Raven4 until then.
https://www.featherweightaltimeters.com/uploads/1/0/9/5/109510427/quick_start_diagrams.pdf
This card normally comes with the altimeters and is used as a template for drilling. You need to print it at the right scale! The Users Manual lists the size as 0.8"x1.8".
SteveThatcher
SMT Designs
That will work. Thanks! I guess I am just used to specifications, etc. Even the drill templates I do always have dimensions included... 
Yep. Dimensioned drawing would be very comforting. What do you think of that idea Adrian?
rharshberger
Well-Known Member
A dimensioned drawing has been posted before, the trick is finding the thread it was in!
SteveThatcher
SMT Designs
I am guessing the raven3 mounting looks to be 1.30 x 0.625" with the overall board size of 1.8" x 0.8"
I took a screen shot, rotated the board to get it level, sized it to exactly 1.8 x .8 and then measured the holes with one of the Photoshop tools I use. If this turns out to be correct, then I will document it as part of the bay schematics I do.
I took a screen shot, rotated the board to get it level, sized it to exactly 1.8 x .8 and then measured the holes with one of the Photoshop tools I use. If this turns out to be correct, then I will document it as part of the bay schematics I do.
SteveThatcher
SMT Designs
the only thing I can't tell from the two page "usage guide" is what the clearance is under the board. If someone has one of these, if you could take a look and let me know - that would be great!
Titan that is Awesome.
SteveThatcher
SMT Designs
Thank you! I was close... maybe someone could snap a picture of the underside, so I can check clearances...
Similar threads
