Leonard, I see in your build that you used all four of the original clear fins: Two on the donor core and two on the outboard boosters.
But I was...
I think that was the problem. Instructions say to set the case assembly aside in a vertical position after gluing to let the epoxy fully cure.
Instructions say two pats of clay. I believe each pat is .25oz., so .5 oz. total.
Part # is 85705, in case you want to verify this.
+1 to Tango Papa and Stickershock23 for decals. However don't know if Tango Papa can do custom work. Worth a try, however.
If your white areas are...
Do you have access to a 3D printer? With Doug's file that would seem to be the way to go.
Choose your poison.
Clockwise, from top center:
Estes Quinstar (NeilW and Second Row's favorite), Estes Hex-3, Art Applewhite Delta Saucer, Quest...
Found this scan on the JimZ site for comparison:
From the SSV Scorpion plans.
Speaking of nose cones, interesting read about the Nike Smoke nose cone in Alway's Rockets of the World. When they replaced the original short 36...
By jove, I think you've got it. Always wondered what kit that was for.
See inset picture.
Boost gliders only, without R/C control.
Nope, you need a delay for boost gliders.
Depends on the glider. Recommended engine for the M2F2 Space...
Type of filament? Heated bed? Looks like you have some gaps in the base and just above the shoulder.Try posting that pic and a thread in the 3D...
Found it. Peel and stick metallized decals. As Initiator mentioned, balsa fins. And balsa nose cone. Still, a fun build. Might be easier to get...
Slightly smaller body tube: BT-55 instead of BT-56/ST-13.
Pretty close if you're not picky.
Don't know if the OP prefers a reproduction or a clone.
You can stitch pgs. 5 and 6 together from the plans to get a template for the boom. Use the nose block pieces from the Semroc balsa sheet to...
Separate names with a comma.