Not that there’s anything wrong with posting here but you may get more attention to this as a build thread rather than a photo finish thread in...
Whatever paint you use next might be smart to try it on a scrap piece before you try it on your rocket. Scrap piece should Scrap piece should...
Make them out of poster board all the time.
Okay, I may tag team this one with you (you do the Jersey Version, I will do Tennessee)
Full square rocket body (sides will open as brakes), fins...
This is exactly the design for most of my helicopter and air brake recovery rockets at launch and on ascent. The entire rocket body is square,...
Wow I didn't know the fat 24 mm C engines were available again. Good to know.
You have plenty of fin surface area. The asymmetry should not cause instability ( net trajectory will be straight)
You may get a bit of...
Like the paint scheme.
Hope you get some great flights!
Black magnum sharpie ,(kind of an oxymoron) would allow you to apply flat black to the inside of a tube up to about 1/2 inch.
The pic makes it LOOK like there is a big CHAD staged Estes cardboard motor in the pod!
I had the SkyCycle. I remember one “flight” where it ended up doing a land shark routine!
Hare we go........
We can only hope this doesn’t bring out some cheep posts about other barnyard animal noises. That would be really baaad.
Separate names with a comma.