On the last few kits I've built, I've been noticing that the joint between the launch lug (LPR kits) and the body tube seems to get a lot of rough spots / porosity in the glue fillet (white or yellow glue used). It looks "ragged" and bugs me.
It's almost like the two round surfaces or the glue being used is causing air bubbles or something. I try to re-fillet with white glue (supposed to shrink less, right), but it doesn't seem to help much. I'm not having any problem with fin fillets by comparison.
Anyone have any tips on getting that particular fillet to be smooth? I might try FnF (for finish, not for strength) but that might be a little hard to sand down.
It's almost like the two round surfaces or the glue being used is causing air bubbles or something. I try to re-fillet with white glue (supposed to shrink less, right), but it doesn't seem to help much. I'm not having any problem with fin fillets by comparison.
Anyone have any tips on getting that particular fillet to be smooth? I might try FnF (for finish, not for strength) but that might be a little hard to sand down.