Sold 98mm FW CF tube anyone?

[REK]

Hello TRF,

after getting some help from Scrapmaster I am looking to run my filament winder again in the hopes it gives me a good tube. It will be 98mm ID and the OD can be either thin, standard or thick wall. I have resin that is resistant to 390F. Max tube length will be 58”. The winding pattern will be an initial 90 degrees and then followed by the rest at 57 degrees.

Please note that these tubes will not be sanded smooth. Other wind angles are possible, but I chose 57 in case you want to turn it into a motor case. The carbon will be a standard modulus carbon.

I’ll be asking $180 for the tube plus shipping. Let me know if your interested so I may get to working. Thank you

 

[RNR883]

Put me I line for a standard wall.

 

[REK]

Put me I line for a standard wall.

You got it

 

[Evolvant]

I'd be interested. Did you end up making these? PM Sent.

 

[REK]

I'd be interested. Did you end up making these? PM Sent.

Unfortunately no, but I’d go ahead and make one for you.