Tim51
Well-Known Member
Hi all
So this is just a 'please confirm' I've done this right' sort of thread:
Checking a 38 2 G White Thunder load the nozzle was loose and the grains slipped out, luckily hitting something soft. They're undamaged by the drop but I haven't disassembled this motor before. Now I'm putting the motor back together, hopefully in the right way. I can tell which way the forward one fits because of the pellet. But I see the rear grain has a concave surface. Which way round should this grain go? My sense is it should be as in my sketch below, with the concave surface facing forwards. Is this correct?
So this is just a 'please confirm' I've done this right' sort of thread:
Checking a 38 2 G White Thunder load the nozzle was loose and the grains slipped out, luckily hitting something soft. They're undamaged by the drop but I haven't disassembled this motor before. Now I'm putting the motor back together, hopefully in the right way. I can tell which way the forward one fits because of the pellet. But I see the rear grain has a concave surface. Which way round should this grain go? My sense is it should be as in my sketch below, with the concave surface facing forwards. Is this correct?