I wasn't planning on it, but I sure could.very cool. were you going to add that little tip part of the fins back on top of the joiner ring?
View attachment 412850
Sirius Rocketry had some single Estes ones that I ordered.You reqlly took my suggestion and ran!
Where will you get a 2nd nosecone?
Also, using the stock mean machine fins (even with your additions) looks a little small to be effective for this much shorter rocket
Thanks for the idea. It looks a lot better with those on there.very cool. were you going to add that little tip part of the fins back on top of the joiner ring?
View attachment 412850
I was able to do a single tube simulation and it looked great. Still can't figure out how to do dual tubes on rocsim.Fantastic!
Any luck simulating it for stability and motor delay?
Cg is forward of cp so it will be stable.Fantastic!
Any luck simulating it for stability and motor delay?
I tried it with a pod but couldn't get the pod to move up to the same height as the main tube. I ran it anyway and it went well. I am not at my computer but I think the double went 100 ft higher at around 470ft?I think rocsim can do the double things, Im qilling to bet it has to do with Pods
If i was doing it in OpenRocket, Id make a tube with the same cross sectional area as the two tubes, cluster mount, and override the mass to match
Enter your email address to join: