open rocket question

[bobby_hamill]

Is there a way to print the open rocket 3D finished view at full size ?
I have a large format printer that is 42 inches wide and the roll of paper is 100 foot long, so
printing will not be a problem

Thanks

Bobby

 

[K'Tesh]

Take a screen capture, then use your graphics program of choice, and rescale it as needed. Can't vouch for the sharpness of the image

 

[gorillamotors]

This is another question using open rocket. I set up my rocket using a main chute ejection at 500 feet. I do my motor tests and all is fine. I save the file. But when I reopen the file all that info is gone and I have to reset the 500 feet again. Is there a default for electronic altimeter settings?

 

[K'Tesh]

This is another question using open rocket. I set up my rocket using a main chute ejection at 500 feet. I do my motor tests and all is fine. I save the file. But when I reopen the file all that info is gone and I have to reset the 500 feet again. Is there a default for electronic altimeter settings?

Could you post the .ork file? So others could see if they can duplicate your problem?

 

[dhkaiser]

Are you seting the 500 as your default?

 

[gorillamotors]

Are you seting the 500 as your default?

Where is that located?

 

[dhkaiser]

Top menu - Motors & Configuration/Recovery there set "altitude 500 ft" then "Select deployment" menu and chose "Change all config...

 

[gorillamotors]

Top menu - Motors & Configuration/Recovery there set "altitude 500 ft" then "Select deployment" menu and chose "Change all config...

Thanks.