Got the MC Go Devils that I ordered on Wed. Along with it came a sampler pack of Rocketpoxy, had never used it before. First, learned a lot about fillets using tape. Have always just pulled them with my finger after using a syringe to apply a bead. Never had a need for tape method. But was planning on no paint, just clear coat on these. First ones, I waited to long to pull the tape and got a torn strip under the poxy, had to pick out with exacto knife. One fillet, I let it set up to long and was hard to pull, again with just finger. But nearing the end of the 26 fillets, yup bought 3 of em, I encountered flakes in the glue. Had to pick them out of the poxy. Tried mixing the hardener to break them up, just made them smaller. Tried heat, still had to pick them out, they would not flow into the fillet. Has anyone encountered this before?