Find the missing dimension in the diagram...
Nope, try again
The air frame diameter is actually shown 3 times in the diagram.You missed that the airframe diameter was not shown . . . So, what else is missing ?
The air frame diameter is actually shown 3 times in the diagram.
That's the one......Second stage vane shaft centerline relative to vane pad...
How's this project going?
Four. It's given as "1.25" on the base extension line (straight up from the word "dimension" in "All dimensions are..."The air frame diameter is actually shown 3 times in the diagram.
Four. It's given as "1.25" on the base extension line (straight up from the word "dimension" in "All dimensions are..."
Well, not really but close -> 0.62 + 0.62 = 1.24
But close enough for the Martin-Marietta model shop to produce desk ornaments for the various execs/generals/politicians...
I'm going to stick with cardboard. No particular reason other than I know it works.I'm undecided if I should just make centering rings out of card board like the original Estes version or design some to 3D print...
Enter your email address to join: