My next launch plan will use a P54 CTI K2045 VMAX. My rocket is DD and will use the on board altimeter for the separation events. Normally this would not be any big deal but the K2045's stock ejection delay of 15 sec. is too close to the simulation's optimum delay of 14.8 sec. So I plan to remove the ejection charge from the K2045. I've read in CTI's FAQs that it's OK to remove the charge.
My question is should I epoxy the 'touch hole" or leave it alone. It seems that it might be best to seal up the hole but I wanted to see what others have to say about it...
Thanks.
My question is should I epoxy the 'touch hole" or leave it alone. It seems that it might be best to seal up the hole but I wanted to see what others have to say about it...
Thanks.