SacEsq
Well-Known Member
- Joined
- Jan 23, 2012
- Messages
- 750
- Reaction score
- 5
Last week at October Skies I decided to use my 29/240 case for the first time. When I wen tot load the grains and liner it would not fit. Even with a generous amount of lube the liner would get stuck approximately 1/3 to 1/2 way into the case. Luckily I was able to pull it out and clean everything up. After looking it all over I decided to peel off the outer layer of the liner tube. After that the motor loaded nicely into the casing.
I was just wondering ... is this normal?
I was just wondering ... is this normal?