n3tjm
Papa Elf
Here are the STL's for the components I made to use MakerBeam 10x10mm rails with your rockets. While you can get them in a single length, I find it more cost effective to get them in a smaller lengths and join them together.
Here is the Rails I used
https://www.amazon.com/gp/product/B00G2DNU4M/ref=ppx_yo_dt_b_asin_title_o02_s01?ie=UTF8&psc=1
Rail Joiner.stl - Joins two Micro-rails together.
Rail Sleave.stl - Fits over Rail Joiner. Glue in place to prevent rails from seperating at the grain of the print.
Porta Pad Rail Adapter.stl - Allows you to use Porta Pad E as a base for useing a Micro Rail
Adapter Sleave.stl - Fits over Porta Pad Rail Adapter.stl. Glue in place to prevent rail from seperating at the grain of the print.
Rod Adapter.stl - Allows Micro Rail to be attached to 3/16 Rod.
Rail Stand Off.stl - Prevents the rocket from sliding off the end of the rail.
Basic Micro Lug.stl - Print and glue onto your rockets so they can use the micro rail!
Here is the Rails I used
https://www.amazon.com/gp/product/B00G2DNU4M/ref=ppx_yo_dt_b_asin_title_o02_s01?ie=UTF8&psc=1
Rail Joiner.stl - Joins two Micro-rails together.
Rail Sleave.stl - Fits over Rail Joiner. Glue in place to prevent rails from seperating at the grain of the print.
Porta Pad Rail Adapter.stl - Allows you to use Porta Pad E as a base for useing a Micro Rail
Adapter Sleave.stl - Fits over Porta Pad Rail Adapter.stl. Glue in place to prevent rail from seperating at the grain of the print.
Rod Adapter.stl - Allows Micro Rail to be attached to 3/16 Rod.
Rail Stand Off.stl - Prevents the rocket from sliding off the end of the rail.
Basic Micro Lug.stl - Print and glue onto your rockets so they can use the micro rail!
