Nacho
Active Member
Hello everyone!
For my next build, instead of friction mounting the motor, I would like to have a "hook" in place so I can easily hot-swap a motor.
I've seen both cylindrical and flat shapes:
What material should I get for this? I have some experience trying to bend a servo rod for a RC plane and that was hard as *!*$%!**.
This is going to be used to retain D/E motors.
Thanks a lot!
~Nacho.
For my next build, instead of friction mounting the motor, I would like to have a "hook" in place so I can easily hot-swap a motor.
I've seen both cylindrical and flat shapes:
What material should I get for this? I have some experience trying to bend a servo rod for a RC plane and that was hard as *!*$%!**.
This is going to be used to retain D/E motors.
Thanks a lot!
~Nacho.