I have used your magnetic switches in all of my bays and plan to continue. My biggest issue is I want to solder my wires and screw it down, which make the screw not sit flat. I have taken to looping the wire and soldering it so it forms a washer of sorts... It would be nice if there was room to solder the wire flat on the board (not through) that would be out of the way of the screw. So maybe a rectangular pad outside the area of the screw head.
Brian, I just use solder lugs to connect to the switch board. Very easy and secure. Heat shrink over the wired lug. Also, you can turn the lug out/up to avoid interfering with your mounting arrangement.
John
TRA #14574 L2