- Joined
- Jan 17, 2009
- Messages
- 669
- Reaction score
- 10
Hi-
Working on a project for a customer, I need to make a clearance hole in a ring that will go over the threaded portion of an Estes retainer for 29mm. Just the threaded bit, not the actual cap. Would one of you fine folks out there give me a quick measurement of the OD of the threaded portion? Doesn't need to be ultra precise (although that's good), within a 1/16" would do.
Many thanks,
Nat Kinsey
UpscaleCNC
Working on a project for a customer, I need to make a clearance hole in a ring that will go over the threaded portion of an Estes retainer for 29mm. Just the threaded bit, not the actual cap. Would one of you fine folks out there give me a quick measurement of the OD of the threaded portion? Doesn't need to be ultra precise (although that's good), within a 1/16" would do.
Many thanks,
Nat Kinsey
UpscaleCNC