Pro75 Case Help

Hi everyone. My Pro75 5 grain case is well used and upon inspection last night, I noticed some pitting at the area where the nozzle o-ring seats against the inside of the case.

I can't feel them with my fingers but the tip of a pencil or similar will "stick" a little. What kind of risk am I looking at for continuing to fly the case? I should mention that I already have an L3200 Vmax (3 grain) that I would fly as the next flight.

Thanks for any advice on this.

ITS FINE, I would add a bit of grease to the orings though

No problem. Make sure to glue in the L3200 grains!

Jeroen

Thanks for the replies. I guess that's all the reassurance I need then, especially since Jeroen says it's ok.

Jeroen, I will be sure to bond the grains per the instructions!

Well you guys were right! I flew the L3200 with no issues. What an awesome motor.



Ground Video:
[video=youtube;gok69Db4OQ0]https://www.youtube.com/watch?v=gok69Db4OQ0&list=UU0fx-IFj-Kr_alx8_i7uqtg[/video]

HD Onboard Video:
[video=youtube;xJ2xaevDyXU]https://www.youtube.com/watch?v=xJ2xaevDyXU[/video]

My blog post for this launch:
https://allenp3.blogspot.com/2014/10/positive-ascents-final-flight-l3200-vmax.html

Additional Pictures:
https://allenp3.blogspot.com/2014/10/positive-ascents-20th-flight-additional.html