dixontj93060
Well-Known Member
- Joined
- Feb 19, 2009
- Messages
- 13,083
- Reaction score
- 45
I like the plywood overlay--looks nice. Just be careful the CG isn't creeping too far back.
I like the plywood overlay--looks nice. Just be careful the CG isn't creeping too far back.
I need to make a few decisions.
Originally, I was going to use the 18" BT60 for the base and the transition, but decided it would be too short. So I used another piece for the transition. Now I think the base BT60 is too long. I'm thinking of cutting 2~3 inches off.
I also have to figure out the launch lug. With 2.75" tube, I have to move the lug out. I see 3 options
1) - glue the lug to a fin
2) - add a single stand-off between fins just for the lug
3) - Add three strakes to be symmetrical (one of which will just happen to have the lug attached). But I am concerned it will take away from the pod. As some say - less is more
What did you use to create/print the design for the trusses? They look great!
I like the plywood overlay--looks nice....
Not so sure about the rivits--I think if they were smaller--a little more delicate-- What are your thoughts on color ??
What are those rivets made out of? Marc
Enter your email address to join: