DanDare
Well-Known Member
- Joined
- Jan 30, 2014
- Messages
- 62
- Reaction score
- 0
Im planning to build a A4/V2 model. Decided to transcript image files to AutoCad as to store the plans and general handling. I've started from the body so far but now comes the fins. Scanning distortions from original plans is something common but there's some misalignment between fins that are repeating through different source plans. Maybe a repeated mistake (classic Ctrl-C Ctrl-V)?
These are the "original" plans I'm using:
And these are the details on fins. I draw the red lines as reference. The insertion point of fins into body seems different one to another. The same pattern can be checked at the bottom part of fins (i.e. not equally leveled).
So, whats going on? Maybe fins are just like that considering specific working aspects of the V2? What should I do ath this point? Adapt and make all fins leveled the same ?
Apreciate any clue !
These are the "original" plans I'm using:
And these are the details on fins. I draw the red lines as reference. The insertion point of fins into body seems different one to another. The same pattern can be checked at the bottom part of fins (i.e. not equally leveled).
So, whats going on? Maybe fins are just like that considering specific working aspects of the V2? What should I do ath this point? Adapt and make all fins leveled the same ?
Apreciate any clue !