Used some of the milled Carbon and milled Kevlar I got from RobMartinez702 to patch a hole in my tire on my Yukon.
I got the warning from the tpms, and checked it and it was at 22psi. I made it to the store to get back to 38, and then when the pump shut off I could hear the hiss, so I made it back to the house and found the hole, dried the area with a towel and 90% rubbing alcohol, stuck a super glue into it and squeezed a bunch into the hole, then poured a little milled carbon on it and pressed it with parchment paper into the gouge. More super glue, then Kevlar pulp, then more Carbon, and so on in layers, and by the third pressing of milled goodness and CA, the bubbles had stopped, so I continued a few more layers, using cotton balls now to press things into place and leave some CA cotton in the mix.
It is holding, and will hopefully do so overnight til' I can address the situation properly in the morning.
Thanks again to Rob, and buy his milled and chopped composites, as they are good for fixing just about anything.
ETA: Yup, still holding.