Hallo Boris,
first of all, thank you for the great work you have done so far! Great work
I would like to say, that i am have the same strange behavior with the Code. My Alti is a Breadboard Version with an Arduino Nano 5V, the BMP and 24LC512.
Took version 1.3 from your Page and mostly it is working fine. So what i have done......
Flight List: --Power on/off, open serial connection every time and pressed w;
..... here are the results->
Flight Nbr: 1 Start address: 101 End address: 340
Flight Nbr: 2 Start address: 341 End address: 608
Flight Nbr: 3 Start address: 609 End address: 820
Flight Nbr: 4 Start address: 821 End address: 1072
no recording :cry:
no recording :cry:
no recording :cry:
…..
Please, can you check with your Version that your Code is recording up to full 25 flights?!
Here is a second one (Flight Nbr: 2 End adress is lower than start adress ->reset button pressed Arduino nano)
Flight List:
Flight Nbr: 1 Start address: 101 End address: 372 normal, pressed w;
Flight Nbr: 2 Start address: 373 End address: 372 :cry: reset pressed, no power off, pressed w;
Flight Nbr: 3 Start address: 373 End address: 676 power off/on, normal pressed w;
Flight Nbr: 4 Start address: 677 End address: 1000 power off/on, normal pressed w;
Flight Nbr: 5 Start address: 1001 End address: 1324 power off/on, normal pressed w;
no Recording :cry: power off/on, normal pressed w;
no Recording :cry: power off/on, normal pressed w;
….
What i can see, when the start adress is much over 1000 it will stop recording. ....sorry i would like to say, that it hangs after it say "We have a liftoff"!
Do you have any ideas?
Best regards,
Kai