Dark Star Fanatic
I was unloading my (Unfired) K490 because I didnt get a chance to fly it again, I ran out of time. I noticed that my Nozzle assembly is crooked in the liner. Is this epoxied in, or will it align itself when the case goes together? Just getting a little worried. Its only off by a few mm so it might not even matter. Any ideas?
Tom
NAR #83620 L2 soon to be L3
NAR 89056 L3
Without pictures it's really hard to tell what you're concerned about. The aft closure and nozzle just fit into the end of the liner, so it might be "crooked in the liner", but this is nothing to worry about. But I'm not sure if you're talking about the nozzle itself.
http://pro38.com/pdfs/Pro54_instructions.pdf
Dark Star Fanatic
Im talking about the nozzle itself in the liner tube. It is off centered and I was wondering if it was epoxied in. Ill take a pic in a second
Tom
NAR #83620 L2 soon to be L3
hybrid user
The nozzle is not epoxied in.
Karl Baumheckel
TRA 11594 L3
Senior Member
The nozzles are CA'ed into the liner to keep everything together during assembly. It will sear itself against the closure ring once under pressure.
Posting Permissions
Reply With Quote