Electronics bay for AeroTech Arcas

[1tree]

Well today I received my replacement Arcas. (The original had an engine malfunction on its maiden launch.) Anyway I was thinking that the coupler could double up as an electronics bay. I am looking for any input that might be found on the idea.

[KenRico]

You need to talk to Bill at BMS.

Have him cut two bulkheads to fit , one to fit inner bt and one to fit inside coupler . Have him put 1/4 inch hole in the center in each. Can glue together with an eyebolt threaded and tightened with nuts for and aft for proper alignment.

Make two end caps, then mark one with a line dissecting the smaller sides circle into two halves. Then take a washer and mark the center of the washer on the line with the edge of the washer just inbounds of that edge. Bolt the two caps together bigger back to bigger back and drill your marks with 1/4 inch bit.

Unbolt and you be gangsta on the av bay and cap it ! Cap it ala CJ !

Kenny