Just bought my first mid-power SU motor (econojet F20-7W) for my Quest Big Dog. Looking over the instructions it seems fairly easy with a couple expections:
1. Cardboard spacers? Instruction No. 5 reads: "IMPORTANT - Please read the following: To safely use Econojet "f" motors to launch an AeroTech Consumer Aerospace rocket, the installation of two spacer tubes in front of the motor is required. ... " Is this only if using those rocket kits? Am I correct in assuming that frisction fitting is all that is necessary in my Big Dog as these appear to have the plastic thrust ring?
2. Copperhead Igniter Installation Up till now I have only used Estes solor igniters and they have two wires coming out of the motor, whereas it appears that the Copperhead Igniters only have a single wire coming out. How do you attach the leads from the launch controller to just a singly igniter wire?
Sorry for what is likely very obvious and noobish questions.