Marc, you have done a great job in making the jig, kudos to you. Do you think a piece of peg-board would have worked out better while drilling the holes in the base-plate and in the wood plate attached to the aluminum? This question now has brought to my mind, the little there is left, but one could use the factory cut edges of the peg-board as guide line to draw for the laying out the different degrees of angle needed, 45, 90, 135, 180 and etc? right???
I do like your design and your comments while building the jig. It was a hoot in reading and picturing oneself in the same boat, but without AFLAC in the boat with you.
Bill
Bill,
That's a really good idea, which didn't occur to me. So, excellent first post!
I'm also considering ideas that would give me continuously adustable mounting as well. I saved a second set of wood/parts to build a "Mark 2" version of this and may incorporate either the peg board or other ideas.