After giving the Canadian Government 15% of the cost of the kit, adapter and shipping (yes, shipping!) on my debit card (they don't take credit cards either! lol...) the EZI kit is sitting in my house.
I have to go out and tonight and get some CA, wood glue, and some odds and ends thanks to the suggestions in my "ezi build suggestions" thread when I go get some supper, but the building will start tonight!
Quick question: Whats the best way to mount the fore rail button? I remember seeing an apogee video about putting it at the CG but I forget how they suggested mounting it. Was it a nut on the inside of the body tube, or using some epoxy clay inside? I can't find the video.
What say you?
(EDIT... PS - The spirals are so shallow I'm not sure how to proceed with filling them... do I use epoxy clay snakes pressed into the grooves then shaved or can I just prime them?)
I have to go out and tonight and get some CA, wood glue, and some odds and ends thanks to the suggestions in my "ezi build suggestions" thread when I go get some supper, but the building will start tonight!
Quick question: Whats the best way to mount the fore rail button? I remember seeing an apogee video about putting it at the CG but I forget how they suggested mounting it. Was it a nut on the inside of the body tube, or using some epoxy clay inside? I can't find the video.
What say you?
(EDIT... PS - The spirals are so shallow I'm not sure how to proceed with filling them... do I use epoxy clay snakes pressed into the grooves then shaved or can I just prime them?)
Last edited: