• If you have bought, sold or gained information from our Classifieds, please donate to Rocketry Forum and give back.

    You can become a Supporting Member which comes with a decal or just click here to donate.

APS 38/640 motors and extras

The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

DeeRoc29

Well-Known Member
Joined
May 25, 2011
Messages
1,430
Reaction score
632
Location
CA
Three cases, three aft closures, three fwd closures with ejection wells sealed with JB Weld, one .390 nozzle, one .298 nozzle, o-rings, and about 14 inches of standard 38 liner/casting tube. One of the cases is pretty new, the other two have seen use but are in working order. Excellent for experimenters.

$150 shipped to CONUS. Paypal preferred.

image_zpst8i7cpsj.jpeg
 
Also included but not pictured is a length of .75" diameter garolite tubing from McMaster for smoke grains.
 
I can't believe these see still here. I have 2 of the 54mm and a few APS loads.

I think it is because a lot of people here were not around when APS almost got going hence a lack of familiarity.

It is a shame as they made some really great motors.

The hardware is really high quality stuff
 
To the EX'ers out there...these cases are 1.334" ID like Loki. They accept standard liners/casting tubes!

If I didn't already have one and was more active, I'd be all over this!
 
I would have guess Kosdon sized by the 38/640 designation.

What the heck, I'll take them. PM on way.
 
Back
Top