dr wogz
Fly caster
I'm doing a scratch build with a non standard tube dia. And I thought: "What am I gonna do for a nose cone?" CRs are easy, but nose cones can be tricky.
And low & behold, I have CAD, I've been doing CAD designs since we stopped using pencils! and I have a 3D printer at my disposal!
So, what can I whip up in about 10 minutes?!
dia. is roughly 1.5" by 3.75" long with a typically wall of about 0.030" (dims aren't set yet, need to verify & tweak) but it's a start. (And there's about a 1/2hr left in the day..) I'll be adding a #8 eye bolt in the protrudy hole thingy..
Yes?
No?
PLA, red or silver..
And low & behold, I have CAD, I've been doing CAD designs since we stopped using pencils! and I have a 3D printer at my disposal!
So, what can I whip up in about 10 minutes?!
dia. is roughly 1.5" by 3.75" long with a typically wall of about 0.030" (dims aren't set yet, need to verify & tweak) but it's a start. (And there's about a 1/2hr left in the day..) I'll be adding a #8 eye bolt in the protrudy hole thingy..
Yes?
No?
PLA, red or silver..