Thanks for the compliment, but mine is still in primer and hasn't been photographed yet.
The wings and stabilizer are at the standard 120*-120*-120* position on the tube for a three fin rocket.
The canards are at 90* from the stabilizer, projecting straight out from the BT.
All fin root edge, trailing edge and fin tip are at 90* from each other.
The wings and stabilizer are mounted flush with the rear of the main BT. The canards are mounted 4.25" from the rear of the main BT.
The dimensions for the wing are:
Root edge 2.5"
Trailing edge 3.5"
Wing tip 0.5"
Leading edge 4.0"
Stabilizer dimensions are:
Root edge 1.75"
Trailing edge 2.0"
Stab tip 0.5"
Leading edge 2.5"
Canard dimensions are:
Root edge 0.625" (5/8")
Trailing edge 0.75"
Can. tip 0.25"
Leading edge 1.0"
The 1/8" dowel is cut into two 2.0" pieces for the wing tips, and two 3.0" pieces that go along the sides of the launch lug. These are mounted 2.0" from the rear of the main BT. Launch lug is 2.25" from the rear of the main BT.
The motor mount sticks out the back of the rocket 0.5"
I hope this helps.