BryRocket
Well-Known Member
- Joined
- Jun 19, 2017
- Messages
- 516
- Reaction score
- 175
Hello,
I have a Gen3 75mm 4g CTI case and 2 spacers. I intend to fly a 2 grain reload first time around. This probably seems like a dumb question but I couldnt find the answer (or confirmation) in the instructions so Im just looking to firm up what I believe to be true and get some peace of mind.
Anyway, the spacers just go into the case immediately forward the forward closure and then screw in the forward retaining ring correct?
Also, is there any other consideration when using the spacers?
I know the instructions mention building it up in a particular order, omitting the last fwd grain spacing O ring, etc. It then mentions observing said O ring when you place the fwd seal disk. If I follow the instructions and just add the fwd seal disk, fwd closure and then the spacers and then the retaining ring, I really wont be able to observe that O ring situation well. Any advice there?
Thanks a ton, Yall!
Sent from my iPhone using Rocketry Forum
I have a Gen3 75mm 4g CTI case and 2 spacers. I intend to fly a 2 grain reload first time around. This probably seems like a dumb question but I couldnt find the answer (or confirmation) in the instructions so Im just looking to firm up what I believe to be true and get some peace of mind.
Anyway, the spacers just go into the case immediately forward the forward closure and then screw in the forward retaining ring correct?
Also, is there any other consideration when using the spacers?
I know the instructions mention building it up in a particular order, omitting the last fwd grain spacing O ring, etc. It then mentions observing said O ring when you place the fwd seal disk. If I follow the instructions and just add the fwd seal disk, fwd closure and then the spacers and then the retaining ring, I really wont be able to observe that O ring situation well. Any advice there?
Thanks a ton, Yall!
Sent from my iPhone using Rocketry Forum