Custom rings and fins needed

The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

JR Anderson

Well-Known Member
Joined
Aug 18, 2011
Messages
66
Reaction score
10
I have some odd size tubes(7.25in dia) and need rings, bulkheads and fins.
Contacted Python Rocketry for the nosecone, but need recommendation for the rings, bulkheads and fins. Any help is much appreciated.
Thanks
John
 
Contact Upscale CNC, aka on TRF "wingarcher" iirc his name is actually Nate Kinsey. He's done a fair bit of custom rings and stuff for TRF'ers.
 
Hadn't seen anything from him in a while, not sure if he was still doing this.
Will get ahold of him.
Thanks.
John
 
Tried two messages though here and nothing.
Any chance of an email address to get ahold of him?
Thanks
John
 
Upscale CNC is still taking orders. I emailed him recently --said he may be busy for a week or so upcoming, therefore, I would encourage patience, but he has always been very good at getting back to customers. He's made a few things for me.


Later!

--Coop
 
Thanks guys, only use PM one other time and wasn't sure if it got sent.
Will get info to you, Just starting the project.
Thanks
John.
 
Back
Top