Eric
Well-Known Member
I'm assembling an Aerotech I364FJ in my 38/720 case. 5 of the 6 grains are wrapped separate and are identical. The 6th unwrapped grain has one end cut flat, just like the other grains.
The other end has a slight concave edge and is coated with what appears to be epoxy.
My question is why is it not cut flat and coated. And where does that grain go in the assembly. The directions make no mention of different grains.
Thanks.
Sent from my VS988 using Tapatalk
The other end has a slight concave edge and is coated with what appears to be epoxy.
My question is why is it not cut flat and coated. And where does that grain go in the assembly. The directions make no mention of different grains.
Thanks.
Sent from my VS988 using Tapatalk