I bought an Aerotech 18mm motor case and some D13-4W 18mm reloads. Trying to assemble them according to the directions is impossible as the liner tube will not go into the motor case. I have tried sanding some of the outside off the liner tube and succeeded in getting the liner tube stuck in the case. getting it out should be simple enough, although getting it out and keeping it usable is probably not happening. Any advice on how to load the next one after I get it out? Is there anywhere I can get just a replacement liner tube? I tried two different liners from the same pack, both were too big to fit. I will probably try the liner from a different pack of reloads, D24-10T, and see if that has the same issue.
This was going to be my first reloadable motor. I am wondering if I should have tried a lager size out first?
This was going to be my first reloadable motor. I am wondering if I should have tried a lager size out first?