I have a stupid situation. I need to open a couple of plywood centering rings by about 2 mm.
I'd like to do it evenly. I would prefer to do it with a jig or some kind of tool but I don't have a router. I would prefer not to hand sand them.
The rings are 7.5 inch with 98mm MMT openings. I am putting two rings together and putting an aluminum retainer through the rings.
That's why I want to open them up.
Does anyone have an idea? I have a drill press and sanding drum but how to jig?
Someone here has done this and is more creative than I am. Help. :wink:
Thanks in advance!
I'd like to do it evenly. I would prefer to do it with a jig or some kind of tool but I don't have a router. I would prefer not to hand sand them.
The rings are 7.5 inch with 98mm MMT openings. I am putting two rings together and putting an aluminum retainer through the rings.
That's why I want to open them up.
Does anyone have an idea? I have a drill press and sanding drum but how to jig?
Someone here has done this and is more creative than I am. Help. :wink:
Thanks in advance!