ecarson
Well-Known Member
- Joined
- Mar 21, 2017
- Messages
- 111
- Reaction score
- 18
Here is .stl file of the design. Hatchbox black ABS printed at 230°C, and bed at 100°C. 100% infill. Speed was 40 mm/s. No supports but I do use a 6mm brim though. 0.4mm nozzle, and 0.2mm layer height. First layer and brim at 30mm/s.
I might add, that I insulated the underside of the heat bed with cork, so I can get very consistent bed temperature there.
I use an enclosure, and pre-heat that. If I can get chamber to 40°C by bed and extruder heat alone, I call it OK. I use a glass build surface cleaned with isopropyl alcohol and then sprayed with Aquanet Extra Super Hold hairspray. I usually get tenacious bed adhesion at build temperature, and when it cools to room temperature I can usually just lift the print off by hand.
View attachment 38mm Motor Retainer.zip
I might add, that I insulated the underside of the heat bed with cork, so I can get very consistent bed temperature there.
I use an enclosure, and pre-heat that. If I can get chamber to 40°C by bed and extruder heat alone, I call it OK. I use a glass build surface cleaned with isopropyl alcohol and then sprayed with Aquanet Extra Super Hold hairspray. I usually get tenacious bed adhesion at build temperature, and when it cools to room temperature I can usually just lift the print off by hand.
View attachment 38mm Motor Retainer.zip