Outside diameter of an Aeropack 38mm retainer *cap*?

the rocketry show
SilicdyneTRF
eggtimer rocketry
Wildman Rocketry
The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I don't have one myself, but the apogee website says a 5cm diameter for the cap, and I called them to make sure the measure was for the cap. They are usually pretty good about this stuff, but I'd listen to whatever forumer who actually has one and posts after me.
 
ScrapDaddy said:
I don't have one myself, but the apogee website says a 5cm diameter for the cap, and I called them to make sure the measure was for the cap. They are usually pretty good about this stuff, but I'd listen to whatever forumer who actually has one and posts after me.
Click to expand...

Apogee does not list a OD for the cap. Look at the bottom of the table. You sure that is not for the retainer?
 

Similar threads

AZ_Ron
Looking for dimensions for a Animal Motor Works 38mm Delay bulkhead
Replies
4
Views
223
AZ_Ron
AZ_Ron
Gunstar
3D Printing Motor Retainers BT-20 and BT-50 Estes compatible
Replies
2
Views
536
Gunstar
Gunstar
E
Wanted Replacement parts
Replies
0
Views
337
emckee
E
Sparkyflyer14
Wanted 38mm FARG
Replies
10
Views
465
cwbullet
cwbullet
plkap74
Ideas for retaining a motor mount adapter on a 3" PML bull puppy
Replies
8
Views
769
conneryc
conneryc

Latest posts

Back
Top