BDB
Absent Minded Professor
- Joined
- Aug 22, 2015
- Messages
- 2,556
- Reaction score
- 938
I really like Eggtimer products. I've enjoyed building a few of them so far, but I think I just screwed my first one up. I have two Quantums. I just completed the build for the second one a couple weeks ago, and, at the time, it powered up and I was able to connect to it via wifi. I just set down to program it tonight, and it won't even start up. I know the issue isn't my LiPo because my other Quantum works just fine. I looked at every joint and they look ok (at least my my crappy soldering standards). The only joint that I suspect could be problematic is on the backside of the unit (pictured below). It's nearly impossible to keep the two solder joints separate, so I did my best. Honestly, the soldering job on my other unit looks a little worse.
Has anyone else experienced anything like this?
Has anyone else experienced anything like this?