Nathan
☢
- Joined
- Apr 19, 2012
- Messages
- 2,230
- Reaction score
- 755
After much cleaning of fiberglass parts I'm finally ready to start building the motor mount.
For epoxy I use Aeropoxy 6209. The motor tube is 36" (and yes it is only 75mm :y. There will be four centering rings; two forward of the fins and two aft of the fins. The forward two rings will be epoxied to the motor tube first. The two aft rings will be added after the MMT is installed and internal fillets are done. This is the lower forward CR, which is positioned so that bottom of the CR will exactly line up with the top of the forward fin slot. Hopefully . . .
For epoxy I use Aeropoxy 6209. The motor tube is 36" (and yes it is only 75mm :y. There will be four centering rings; two forward of the fins and two aft of the fins. The forward two rings will be epoxied to the motor tube first. The two aft rings will be added after the MMT is installed and internal fillets are done. This is the lower forward CR, which is positioned so that bottom of the CR will exactly line up with the top of the forward fin slot. Hopefully . . .