3 Stage MAMMOTH

Advertise with us
SilicdyneTRF
Onebadhawk
The Rocketry Forum

Help Support The Rocketry Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I just realized a possible issue with this system. Have you considered whether this booster will cause problems with the launch rod/rail?

I'm still waiting for my university to repair the large 3D printer, so I haven't printed this thing yet.
 
Your going to need a 1/2 inch rod or rail.
The air frame between the three motor tubes is the same OD as the Mammoth OD (2"/51mm). So there should not be a problem.

Just remember the pegs on the bottom are print supports an need to be removed after the print is done.
 

Similar threads

Kane
Design and Build Thread: ARO-B Two-Stage
Replies
22
Views
2K
Kane
Kane
hermanjc
3D Printed Falcon Heavy with Fall Away Boosters - Builders Kit Interest
Replies
7
Views
1K
RS-25
RS-25
ReynoldsSlumber
Old tractors, new tractors: Flying Pitchfork, Cluster F, TetraJet
Replies
16
Views
622
cwbullet
cwbullet
cwbullet
3D Printing Creality Sonic Pad
Replies
27
Views
4K
cwbullet
cwbullet
eJar0k
RIM-2 Terrier 29/38mm
Replies
9
Views
2K
Rocketclar
Rocketclar

Latest posts

Back
Top