When sanding the epoxy fillets on my V2 I got a little too much on the tail cone.
Too much in a couple places to fill with primer.
I don't think TiteBond would be right product to use here.
And epoxy is much harder than the plastic tail cone, making a bigger problem when sanding.
Has anyone used Tamiya's 87053 Basic Gray putty?
Or the 87095 White putty before?
According to the descriptions, white seams to be more versatile and can be thinned.
I doubt I would need to thin it here though.
Bondo is too coarse for this application and red lacquer putty is too soft.
Too much in a couple places to fill with primer.
I don't think TiteBond would be right product to use here.
And epoxy is much harder than the plastic tail cone, making a bigger problem when sanding.
Has anyone used Tamiya's 87053 Basic Gray putty?
Or the 87095 White putty before?
According to the descriptions, white seams to be more versatile and can be thinned.
I doubt I would need to thin it here though.
Bondo is too coarse for this application and red lacquer putty is too soft.