Tramper Al
Well-Known Member
- Joined
- Dec 31, 2013
- Messages
- 400
- Reaction score
- 36
I also put together a quick Enerjet 1340 mock-up last night - which is to say an overbuilt BT-56 Eliminator with a payload section and 29mm motor tube. I'm still getting the hang of working with the NCR tube cutter.
I made the motor tube flush, though later noticed the 1340 diagram has it extending out a bit. It will be friction fit, as per tradition. I also have not done anything to simulate the plastic coupler, but I may. And the purple payload section needs a decal or two, or something. Would probably look better with the yellow nose cone, though I am trying to conserve them, so will fly it with the black.
Planning to fly it later this month, with the Estes altimeter inside. And thinking about maybe getting a Jolly Logic too.
I made the motor tube flush, though later noticed the 1340 diagram has it extending out a bit. It will be friction fit, as per tradition. I also have not done anything to simulate the plastic coupler, but I may. And the purple payload section needs a decal or two, or something. Would probably look better with the yellow nose cone, though I am trying to conserve them, so will fly it with the black.
Planning to fly it later this month, with the Estes altimeter inside. And thinking about maybe getting a Jolly Logic too.
Last edited: