bobby_hamill
Well-Known Member
I need verification of a measurement for the length of the stripes on the decal for the Estes Payloader II kit # 3022
With the airframe being a BT-50 having a outside diameter of .976" that should give me a circumference of 3.066"
But when I print the decal from a pdf file that is supposed to be at 100% the print results in a stripe length measurement of 3.2500
I would assume the measurement of 3.2500 would allow for a overlap of .184 ( approx 3/16 ) the decal edges ?
Thanks
Bobby
With the airframe being a BT-50 having a outside diameter of .976" that should give me a circumference of 3.066"
But when I print the decal from a pdf file that is supposed to be at 100% the print results in a stripe length measurement of 3.2500
I would assume the measurement of 3.2500 would allow for a overlap of .184 ( approx 3/16 ) the decal edges ?
Thanks
Bobby
